WD Live Hub & 1080p - Problems after installing 3.12.13

WD Legacy Products WD TV Live Hub Discussions
1

Hello everybody, after installing firmware 3.12.13   I am experiencing an issue with HDMI output @ 1080p on my Samsung fullHD television set. Specifically, by using default configuration the displayed area is larger than the screen so I need to scale down by 95% to fit into the screen. Everything works fine when working with HDMI @ 720p.

Has anybody experience the same issue? Is there any solution to this annoying issue?

Looking forward to reading your reply!

Regards,

Fred

2

Have you tried a reset to factory defaults in the setup menu.

Are you sure that there is not a setting on your TV which is causing this.

3

Sounds kinda like TV “Overscan” ? 

Consult your TV User Manual and turn Overscan “OFF” (This Setting is usually located in Advanced Settings). 

(Also make sure the TV is set to 16:9)

4

Thanks a lot for the hint, JoeySmyth. Overscan was enabled. I’m now able to display 1080p by configuring simple scan or 16:9.

5

Yes, i also got same problem…1080p not working in HDMI…

6

Shllu229 wrote:

Yes, i also got same problem…1080p not working in HDMI…

Same problem?  Then the same solution will apply.

7

Shllu229 wrote:

Yes, i also got same problem…1080p not working in HDMI…

If your 1080p is not working at all then its not the same problem. The op’s 1080p was working but overscanning due to his TV setup.